Tightening the Recoil Belt
If you're finding your rowers handle is loosing tension near the front of the rower, the following steps should be followed to tighten the recoil belt.
- Lift your rower to the standing position, then disconnect the recoil belt from the bungee on the underside of the rower.
- Lower your rower back into the active position. Pull the recoil belt out from under the rower, then wrap the belt around the main pulley as shown below one additional time.
- Route the recoil belt back along the inside of the lower pulley as shown above, then under the forward riser as shown below.
- Stand your rower up again, then re-connect the recoil belt to the bungee.
If the above steps do not resolve your issue, please reach out to us at firstname.lastname@example.org with your rowers serial number.